Fire Scheduling

Δ Image 4a: Fire Schedule Worksheet panel

Fire scheduling lets the users to plan how a fire should occur for a set of fire serials over a predefined time scale. The details for those serials can be loaded from Targets that have been already saved using the Target list worksheet or the users can set those details as they wish at the time they create a fire schedule.

Access the Fire Planning worksheet: Fire Mission --> Fire Schedule Worksheet.

Each of the buttons areis described as follows:

• : Add Line button creates an entry in the worksheet.


• : Add Serial button opens the ‘New Fire Serial’ panel for the selected line.


• : Set Hours button activates the ‘Set Hours’ window.


• : Set Observer button is used for setting an observer to the fire serial.


• : Activate button creates a fire mission.


• : Check All button will pause all requested fire missions.


• : Stop Fire button stops the fire missions assigned to the gunline.


• : Clear All button removes the selected entry from the worksheet and ends the fire mission.


• : Delete Selection removes selection made in the Line Table, selected lines will stop fire.


• : Dwell/Rejoin – Carries out the Dwell functionality on a serial(s) when clicked on.  When on Dwell and clicked again, serial will rejoin.


• : Resets the values assigned by ‘Zoom Level’ and ‘Append Minutes’.


•   and   : Zoom- / Zoom+ are used to zoom in and zoom out the serial table.

Δ Image 4b: Set Observer window

Δ Image 4c: Stop Fire Window

Each of the sliders is described as follows:

• Zoom Level: used to zoom in and zoom out the serial table.
• Append Minutes: will append minutes to the time line for the serial table.